能源化学(英文) ›› 2003, Vol. 12 ›› Issue (1): 23-30.

• Articles • 上一篇    下一篇

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

Quanli Zhu, Jian Yang, Jiaxin Wang, Shengfu Ji, Hanqing Wang   

  1. State Key Laboratory for Oxo Synthesis and Selective Oxidation, Lanzhou Institute of Chemical Physics, Chinese Academy of Sciences, Lanzhou 730000, China
  • 出版日期:2003-03-30 发布日期:2003-03-30

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

Quanli Zhu, Jian Yang, Jiaxin Wang, Shengfu Ji, Hanqing Wang   

  • Online:2003-03-30 Published:2003-03-30

摘要: The performance of supported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investigated. An evaluation of the catalysts indicates that bulk molybdenum carbide has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products. The rapid deactivation of the catalyst is also a significant problem. However, the supported molybdenum carbide catalyst shows a much higher methane conversion, increased selectivity and significantly improved catalytic stability. The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier. The bulk or the supported molybdenum carbide exists in the β-Mo2C phase, while it is transformed into molybdenum dioxide postcatalysis which is an important cause of molybdenum carbide deactivation.

关键词: molybdenum carbide, molybdenum oxide, partial oxidation of methane, syngas, deactivation

Abstract: The performance of supported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investigated. An evaluation of the catalysts indicates that bulk molybdenum carbide has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products. The rapid deactivation of the catalyst is also a significant problem. However, the supported molybdenum carbide catalyst shows a much higher methane conversion, increased selectivity and significantly improved catalytic stability. The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier. The bulk or the supported molybdenum carbide exists in the β-Mo2C phase, while it is transformed into molybdenum dioxide postcatalysis which is an important cause of molybdenum carbide deactivation.

Key words: molybdenum carbide, molybdenum oxide, partial oxidation of methane, syngas, deactivation